Verandah Bracket No.1 355x355x32mm Fretwork The 117 fittings are a

The 117 fittings are a retro-fit type fitting designed to be added on to existing structures without the need to dissassemble The 117Y fitting comes complete with 4 socket pieces and 3 plate pieces which enable each kit to be used to make one of the three possible assemblies illustrated below

A water based primer/undercoat is not a necessity (although it wouldn't hurt)

Roof Guard Rails

and/or where there is a requirement for rails to be offset from uprights

Plantation grown finger jointed Radiata Pine that has been H3 treated (suitable for above ground use)

Verandah Bracket No.1 355x355x32mm Fretwork The 117 fittings are aWhere would you normally use a treated timber verandah bracket ? As a decorative corner piece (between a post and facia board), used perhaps on a verandah or pergola. It is supplied as 2 pieces that when attached to the post and facia will form the bracket that you see in the photo. What is it made out of ? Plantation grown Radiata Pine that has been H3 treated (suitable for above ground use). How should you finish it ? A water based primer undercoat